ENDUIT ANTI HUMIDITÉ
ENDUIT ANTI HUMIDITÉ allows the treatment of moist walls and slows the appearance of moisture from the inside and outside of the substracte.
Destination: Indoor/Outdoor use
- Very low COV
- Very easy to apply
PREPARATION & APPLICATION:
Surface Preparation: (Referred to the D.T.U. 59.1 requirements): The surface must be well prepared, perfectly dry, dust-free, with no humidity and salt stains.
Application Tools: Stainless Knife
Dilution: 20% to 30% of water
Application method: Eliminate non-adherent parts. Apply one coat of ODAPRIM or PIGMAPRIM as primer. After 3 hours of drying, Apply two coats of ENDUIT ANTI HUMIDITE H200. To achieve good efficiency, apply at least 2mm of thickness
Spreading-rate: 0.5 to 0.8 Kg/sqm ( Depending on the surface state and the thickness applied)
Drying: Touch dry: 1h
re-coatable: 12 h
Cleaning of equipments: With water, immediately after use
Binder: Special binder
Appearance of the film: Mat
Storage: One year in the closed paint can, as delivered. Store inside in conditions avoiding extremes of temperatures and protect from frost.
the support must be hard, cohesive, clean, sound and dry. It is not advisable to apply below 5°C (41°F) temperature and above 85 % relative humidity level.
NM03-3-009 Category IV Class 4b
Health & Safety:
This product is not classified as dangerous. For more details, consult the safety data sheet.
Estimated quantity: 0.
Estimated total cost *: 0 Dhs TTC.
* the estimate of the price concerns only the selected product, and to have it as finishing it is necessary to apply other products of preparation. This estimate may change depending on the condition of the substrate and the chosen paint system.
* the estimate of the quantity of paint required is given in units (kg or liter), and the purchase is made according to the available footages for each product.