ODASIF is an ecological product, designed for filling cracks in masonry, plaster and wood
ODASIF can fill deep cracks up to 4 cm in one layer without the risk of cracking.
Destination: Indoor/Outdoor use
- Very low COV
- Very easy to apply
PREPARATION & APPLICATION:
Surface Preparation: (Referred to the D.T.U. 59.1 requirements): The surface must be well prepared, perfectly dry, dust-free, with no humidity and salt stains.
Application Tools: Stainless Knife
Dilution: Ready to use
Application method: Eliminate non-adherent parts.
Apply one coat of ODAPRIM or PIGMAPRIM as primer.
After 3 hours of drying, fill holes and cracks with ODASIF up to 4 cm.
Let it dry for 5h.
After drying apply the desired top coat system.
Spreading-rate: Depending on the surface state and the thickness applied
Drying: Touch dry: 1/2 h
re-coatable: 24 h
Cleaning of equipments: With water, immediately after use
Density: 1 +/- 0.05 at 25°C
Viscosity: 1000 +/-300 Po at 25°C
Binder: Aqueous dispersion
Appearance of the film: Mat
Storage: One year in the closed paint can, as delivered. Store inside in conditions avoiding extremes of temperatures and protect from frost.
the support must be hard, cohesive, clean, sound and dry. It is not advisable to apply below 5°C (41°F) temperature and above 85 % relative humidity level.
0.5 Kg, 2kg
NM03-3-009 Famille IV Classe 4b
Health & Safety:
This product is not classified as dangerous. For more details, consult the safety data sheet.
Estimated quantity: 0.
Estimated total cost *: 0 Dhs TTC.
* the estimate of the price concerns only the selected product, and to have it as finishing it is necessary to apply other products of preparation. This estimate may change depending on the condition of the substrate and the chosen paint system.
* the estimate of the quantity of paint required is given in units (kg or liter), and the purchase is made according to the available footages for each product.